Instar IN-8403 2K+ PoE Bedienungsanleitung Seite 25

1 - Bracket
2 - Photosensor
3 - Status LEDs
4 - Dual LEDs
5 - Lens
6 - PIR Detector
7 - Microphone
8 - MicroSD Card Slot
9 - Alarm input
10 - Alarm output
11 - Reset
12 - Network LED
13 - Network Port
14 - Power Connector
4.3. Camera Tools
In the delivery content, you will find 3 tools for loosening the camera bracket,
opening the camera dome from the back to access the cables, and opening the
camera from the glass front to adjust the lens.
Alley Key
Go to https://install.instar.com
Universally adjustable bracket for wall/ceiling mounting
Twilight switch for IR LEDs
Red: Camera on or blinking during firmware update
Blue: On during WiFi, blinking during WPS or reset
2 high-power IR LEDs (@ 850nm)
2 high-power floodlight LEDs
Wide-angle (focal length: 4.3mm / field of view: ~ 90º dia.)
Integrated passive infrared (PIR) motion detector
For noise detection / audio rec.
Slot for MicroSD/SDXC cards (max. 256GB)
- 32GB included inside the camera -
Input for potential free external alarm sensors
Output (relay) can support max. 24V/1A
Press 20 seconds for reset
Off: No Power / No signal, Flashing: Network Signal
RJ45 LAN port / connector for Cat5e LAN cable or higher
For included 12V / 1A power supply
6-EN