Starting A Cycle Wash; Changing The Program Mid-Cycle - Kuppersberg GSM 6072 Bedienungsanleitung

ENGLISH

STARTING A CYCLE WASH

1. Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page «Product
fiche». Make sure that the water supply is turned on to full pressure.
4. Open the door, Press the power button.
5. Choose a program, the response light will turn on. Then close the door, the
dishwasher will start its cycle.
CHANGING THE PROGRAM MID - CYCLE
A wash cycle can only be changed if it has been running for a short time
otherwise, the detergent may have already been released and the dishwasher may
have already drained the wash water. If this is the case, the dishwasher needs to be
reset and the detergent dispenser must be refilled. To reset the dishwasher, follow
the instructions below:
1. Open the door a little to stop the dishwasher, after the spray arm stop
working, you can open the door completely.
2. Press Program button more than three seconds the machine will be in
stand by state.
3. You can change the program to the desired cycle setting.
3 sec
TECHNICAL PASSPORT
Dishwasher
89