Kuppersberg GSM 6072 Bedienungsanleitung Seite 73

ENGLISH
Problem
There are rust stains
on cutlery
Knocking noise in
the dishwasher
Rattling noise in
the dishwasher
Knocking noise in the
water pipes
The dishes are not
clean
Possible causes
The affected items are not
corrosion resistant.
A program
was not run after
dishwasher salt was
added. Traces of salt have
gotten into the wash
cycle.
The lid of the softer is
loose.
A spray arm is knocking
against an item in a
basket
Items of crockery are
loose in the dishwasher.
This may be caused by
on-site installation or
the cross-section of the
piping.
The dishes were not
loaded correctly.
The programme was not
powerful enough.
Not enough detergent
was dispensed.
Items are blocking the
movement of the spray
arms.
The filter combination
is not clean or is not
correctly fitted in the base
of wash cabinet.
This may cause the spray
arm jets to get blocked.
TECHNICAL PASSPORT
Solution
Avoid washing items that are not corrosion
resistant in the dishwasher.
Always run the quick wash program. without
any crockery in the dishwasher and without
selecting the Turbo function (if present), after
adding dishwasher salt.
Check the lip. Ensure the fix is fine.
Interrupt the program and rearrange the items
which are obstructing the spray arm.
Interrupt the program and rearrange the items
of crockery
This has no influence on the dishwasher
function. If in doubt, contact a qualified
plumber.
See PART II: «Preparing And Loading Dishes».
Select a more intensive programme.
Use more detergent, or change your detergent.
Rearrange the items so that the spray can
rotate freely.
Clean and/or fit the filter correctly.
Clean the spray arm jets.
Dishwasher
73