Kuppersberg GSM 6072 Bedienungsanleitung Seite 70

TECHNICAL PASSPORT
Dishwasher
Step 3. Tension adjustment of the door spring
1. The door springs are set at the
factory to the proper tension for the
outer door. If aesthetic wooden panel
are installed, you will have to adjust
the door spring tension. Rotate the
adjusting screw to drive the adjustor to
strain or relax the steel cable.
2. Door spring tension is correct
when the door remains horizontal in
the fully opened position, yet rises to a
close with the slight lift of a finger.
Step 4. Dishwasher installation steps
Please refer to the specified installation steps in the installation drawings.
1. Affix the condensation strip
under the work surface of cabinet.
Please ensure the condensation strip is
flush with edge of work surface.
2. Connect the inlet hose to the
cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into
position.
6. Level the dishwasher. The rear
food can be adjusted from the front of
the dishwasher by turning the Philips
screw in the middle of the base of
70
dishwasher use an Philips screw. To
adjust the front feet, use a flat screw
driver and turn the front feet until the
dishwasher is level.
7. Install the furniture door to the
outer door of the dishwasher.
8. Adjust the tension of the door
springs by using an Allen key turning in
a clockwise motion to tighten the left
and right door springs. Failure to do this
could cause damage to your dishwasher.
9. The dishwasher
secured in place. There are two ways to
do this:
ENGLISH
must be