Saving Energy; Changing The Program Mid - Cycle; Starting A Program - Kuppersberg GFM 5572 W Bedienungsanleitung

TECHNICAL PASSPORT
Dishwasher

SAVING ENERGY

1. Pre-rinsing of
leads to increased
energy consumption and is not
recommended.
2. Washing tableware in a household
dishwasher usually consumes less
energy and water in the use phase
than hand dishwashing when the
household dishwasher
according to the instructions.
CHANGING THE PROGRAM
MID - CYCLE
A program can only be changed if it
has been running only for a short peri-
od of time, otherwise the detergent may
have already been released or the wash
water with detergent has already been
drained. If this is the case, the dishwash-
er needs to be reset and the detergent
dispenser must be refilled.
To reset the dishwasher, follow the
instructions below:
78
tableware items
water and
is used
3 sec

STARTING A PROGRAM

1. Draw out the lower and upper basket,
load the dishes and push them back.
It is commended to load the lower
basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket.
The power supply refer to last
page"Product fiche". Make sure that
the water supply is turned on to full
pressure.
4. Close the door, press the Power
button.
5. Choose a program, the response
light will turn on. Then press the
Start/Pause button, the dishwasher
will start its cycle.
1. Press the Start/Pause button to
pause the washing.
2. Press Program button more than
three seconds the machine will be
in program selection mode.
3. You can change the program to the
desired cycle setting.
4. Press the Start/Pause button , the
dishwasher will start.
ENGLISH