TECHNICAL PASSPORT
Dishwasher
WATER SUPPLY AND DRAIN
Cold water connection
Connect the cold water supply hose
to a threaded 3/4 (inch) connector and
make sure that it is fastened tightly in
place.
If the water pipes are new or have
not been used for an extended period
of time, let the water run to make sure
that the water is clear. This precaution
is needed to avoid the risk of the water
inlet to be blocked and damage the
appliance.
About the safety supply hose
The safety supply hose consists of
the double walls. The hose's system
guarantees its intervention by blocking
the flow of water in case of the supply
hose breaking and when the air space
between the supply hose itself and the
outer corrugated hose is full of water.
ordinary supply hose
64
can burst if it is installed on the same
water line as the dishwasher. If your
sink has one, it is recommended that
the hose be disconnected and the hole
plugged.
hose
hoses completely out from storage
compartment
dishwasher.
supply hose to the faucet with thread
3/4inch.
starting the dishwasher.
hose
from the faucet.
safety supply hose
WARNING
A hose that attaches to a sink spray
How to connect the safety supply
1.
Pull
The
located
2.
Tighter the screws of the safety
3.
Turn water fully on before
How to disconnect the safety supply
1.
Turn off the water.
2.
Unscrew the safety supply hose
ENGLISH
safety
supply
at
rear
of