Disposal And Recycling; Troubleshooting Guide - EINHELL 34.303.30 Originalbetriebsanleitung

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.

10. Troubleshooting guide

Fault
The machine does
not work
Shredding perfor-
mance unsatisfac-
tory
For EU countries only
Never place any electric power tools in your household refuse.
To comply with European Directive 2012/19/EC concerning old electric and electronic equipment and
its implementation in national laws, old electric power tools have to be separated from other waste and
disposed of in an environment-friendly fashion, e.g. by taking to a recycling depot.
Recycling alternative to the return request:
As an alternative to returning the equipment to the manufacturer, the owner of the electrical equipment
must make sure that the equipment is properly disposed of if he no longer wants to keep the equipment.
The old equipment can be returned to a suitable collection point that will dispose of the equipment in
accordance with the national recycling and waste disposal regulations. This does not apply to any ac-
cessories or aids without electrical components supplied with the old equipment.
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers
accompanying products is permitted only with the express consent of the iSC GmbH.
Subject to technical changes
Anl_GC_KS_2540_SPK9.indb 19 Anl_GC_KS_2540_SPK9.indb 19
GB
Possible cause
- No power at the plug
- Machine is switched off
- Overload switch has tripped
- Ejector chute is blocked
- Loading funnel is not secure on the
motor housing
- Blades worn
- 19 -
Remedy
- Check the power cable and fuse
- Switch on machine
- Press control on overload switch
- Clean ejector chute
- Clean interior and tighten safety
screw
- Turn, sharpen or replace blades
20.12.2018 09:19:49 20.12.2018 09:19:49