Water Softener - Kuppersberg GLM 6096 Bedienungsanleitung

TECHNICAL PASSPORT
Dishwasher

WATER SOFTENER

The water softener must be set
manually, using the water hardness dial.
The water softener is designed to
remove minerals and salts from the
water, which would have a detrimental
or adverse effect on the operation of the
appliance. The more minerals there are,
the harder your water is.
The softener should be adjusted
according to the hardness of the water in
your area. Your local Water Authority can
advise you on the hardness of the water
in your area.
Adjusting salt consumption
The dishwasher is designed to
allow for adjustment in the amount of
salt consumed based on the hardness
of the water used. This is intended to
optimise and customise the level o f salt
consumption.
Please follow the steps below for
adjustment in salt consumption.
1. Open the door, switch on the
appliance;
2. Within 60 seconds after the
appliance was switched on press the
programm button for more than 5
seconds to enter the water softener
setting mode.
3. Press the program button again
to select the proper set according to
your local environment, the setting
will change in the following sequence:
H3->H4->H5->H6->H1->H2.
4. Press the On/Off button to end
the setting model.
84
Please check the section 3 «Loading
The Salt Into The Softener» Please
check the section 3 «Loading The
Salt Into The Softener» of PART of
PART II:Generic Version, If your dish-
washer lacks salt. Generic Version, If
your dishwasher lacks salt.
NOTE:
If your model does not have any
water softener, you may skip this section.
Water Softener
The hardness of the water varies
from place to place. If hard water is used
in the dishwasher, deposits will form on
the dishes and utensils.
The appliance is equipped with
a special softener that uses a salt
container
specifically designed to eliminate
lime and minerals from the water.
ENGLISH