Troubleshooting Tips; Troubleshooting & Tips - Kuppersberg GLM 6096 Bedienungsanleitung

ENGLISH

TROUBLESHOOTING TIPS

Before Calling For Service
Reviewing the charts on the following pages may save you from calling for
service.
Problem
Dishwasher doesn't
start
Water not pumped
from dishwasher
Foam in the tub
Stained tub interior
White film on inside
surface
Possible causes
Fuse blown, or the circuit
breaker tripped
Power supply is not
turned on.
Door of dishwasher not
properly closed.
Water pressure is low
Twisted or trapped
drain hose.
Filter clogged.
Kitchen sink clogged.
Wrong detergent.
Spilled rinse aid.
Detergent with colourant
may have been used.
Hard water minerals.
TECHNICAL PASSPORT
Solution
Replace fuse or reset circuit breaker. Remove
any other appliances sharing the same circuit
with the dishwasher.
Make sure the dishwasher is turned on and the
door is closed securely.
Make sure the power cord is properly plugged
into the wall socket.
Make sure to close the door property and latch
it.
Check that the water supply is
connected properly and the water
is turned on.
Check the drain hose.
the filter system.
Check the kitchen sink to make sure it is
draining well. If the problem is the kitchen
sink that is not draining , you may need
a plumber rather than a serviceman for
dishwashers.
Use only the special dishwasher detergent to
avoid suds. If this occurs, open the dishwasher
and let suds evaporate. Add 1 liter of cold
water to the bottom of the dishwasher. Close
the dishwasher door, then select any cycle.
Initially, the dishwasher will drain out the
water. Open the door after draining stage
is complete and check if the suds have
disappeared. Repeat if necessary.
Always wipe up rinse aid spills immediately.
Make sure that the detergent has no colourant.
To clean the interior, use the damp
soft cloth with dishwasher detergent and wear
rubber gloves. Never use any other cleaner
than dishwasher detergent for the risk of
foaming or suds.
Dishwasher
75