Step 3. Tension Adjustment Of The Door Spring; Step 4. Dishwasher Installation Steps - Kuppersberg GLM 6096 Bedienungsanleitung

ENGLISH

Step 3. Tension adjustment of the door spring

1. The door springs are set at the
factory to the proper tension for the
outer door. If aesthetic wooden panel
are installed, you will have to adjust
the door spring tension. Rotate the
adjusting screw to drive the adjustor to
strain or relax the steel cable.
2. Door spring tension is correct
when the door remains horizontal in
the fully opened position, yet rises to a
close with the slight lift of a finger.

Step 4. Dishwasher installation steps

Please refer to the specific installation steps in the installation drawings.
1. Affix the condensation strip un-
der the work surface of cabinet. Please
ensure the condensation strip is flush
with edge of work surface.
2. Connect the inlet hose to the
cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into the
cabinet.
6. Level the dishwasher. The rear
food can be adjusted from the front of
the dishwasher by turning the a Philips
screw in the middle of the base of dish-
TECHNICAL PASSPORT
washer use a Philips screw driver. To ad-
just the front feet, use a flat screw driver
and turn the front feet until the dish-
washer is level.
7. Install the furniture door to the
outer door of the dishwasher.
8. Adjust the tension of the door
springs by using a Philips screw driver
turning in a clockwise motion to tighten
the left and right door springs. Failure to
do this could cause damage to your dish-
washer.
Dishwasher
73