Filling The Rinse Aid Reservoir - Kuppersberg GLM 6096 Bedienungsanleitung

ENGLISH

FILLING THE RINSE AID RESERVOIR

Rinse-Aid indicator
1 Remove the rinse reservoir cap by
lifting up the handle
2
Pour the rinse aid into the dispenser,
being careful not to overfill.
TECHNICAL PASSPORT
2
3
Close the cap after all.
Adjusting the rinse aid reservoir
Adjusting the rinse aid reservoir To
achieve a better drying performance
with limited rinse aid, the dishwasher is
designed to adjust the consumption by
user. Follow the below steps.
1. Open the door, switch on the
appliance.
2. Within 60 seconds after the
appliance was switched on press
the program button for more than
5 seconds, and then press the Delay
button to enter the set model, the rinse
aid indication blinks as 1Hz frequency.
3. Press the Program button again to
select the proper set according to your
using habits, setting the will change in
the following sequence: D3->D4->D5-
>D1->D2->D3. The higher the number,
the more rinse aid the dishwasher uses.
4. Without operation in 5 seconds or
press the Power button to complete the
setup and exit the setting mode.
Dishwasher
89