T+A P 3100 HV Betriebsanleitung Seite 45

Table of examples
Equalizer settings
CD content
Now select the highest value, and set an equalizer at this frequency. Select the
reduction in such a way that the curve in the table is as even as possible.
Example: if an emphasis by six fields occurs at 45 Hz, then you should set
equalizer 1 to 50 Hz and -7.5 dB.
Repeat this procedure starting from track 2 (right: track 22). The equalizer you
have just set may need to be re-adjusted subsequently. If the setting is good,
then the next equalizer can be adjusted to correct the next emphasis, if any (in
our example 100 Hz).

It is important to adjust only one equalizer at a time, and then to record the
measured data again, before you adjust a second equalizer.
 The P 3100 HV's equalizers allow maximum amplification of 6 dB, correspon-
ding to four times the power at the nominal frequency. This could overload the
loudspeakers mechanically and electrically. The amplification function of the
equalizers must always be used very cautiously!
Track left channel
1
Pink noise left
2
25 Hz and 30 Hz
3 30 Hz and 35 Hz
4 35 Hz and 40 Hz
5
40 Hz and 45 Hz
6
45 Hz and 50 Hz
7 50 Hz and 55 Hz
8 55 Hz and 60 Hz
9
60 Hz and 65 Hz
10
65 Hz and 70 Hz
11 70 Hz and 75 Hz
12 75 Hz and 80 Hz
13
80 Hz and 90 Hz
14 90 Hz and 100 Hz
15 100 Hz and 110 Hz
16
110 Hz and 120 Hz
17
120 Hz and 140 Hz
18 140 Hz and 160 Hz
19 160 Hz and 180 Hz
20
180 Hz and 200 Hz
Track right channel
21
Pink noise right
22
25 Hz and 30 Hz
23 30 Hz and 35 Hz
24 35 Hz and 40 Hz
25
40 Hz and 45 Hz
26
45 Hz and 50 Hz
27 50 Hz and 55 Hz
28 55 Hz and 60 Hz
29
60 Hz and 65 Hz
30
65 Hz and 70 Hz
31 70 Hz and 75 Hz
32 75 Hz and 80 Hz
33
80 Hz and 90 Hz
34 90 Hz and 100 Hz
35 100 Hz and 110 Hz
36
110 Hz and 120 Hz
37
120 Hz and 140 Hz
38 140 Hz and 160 Hz
39 160 Hz and 180 Hz
40
180 Hz and 200 Hz
45