T+A P 3100 HV Betriebsanleitung Seite 36


Remote control receiver

Screen


Screen divisions
36

When using the remote control system please point the F3001 handset in the
direction of the receiver.
It is essential to prevent potentially interfering light (from fluorescent lamps and
energy-saving bulbs) falling directly on the receiver, as this may markedly
reduce the effective range of the remote control system.
The line of sight between the F3001 and the remote control receiver in the
P 3100 HV must not be interrupted by any obstacles. Installing the P 3100 HV
behind the glass doors of a cabinet will also adversely affect the remote control
system.
The operating range of the F3001 remote control handset with the internal infra-
red receiver of the P 3100 HV is about 4...5 m. In cases where operation from a
greater distance is desired or where the P 3100 HV is placed outside the direct
line of sight from the remote control handset, the external IR-receiver E2000
from the accessories can be connected to the P 3100 HV (refer to p. 43,
paragraph RC IN). By placing the E2000 at a proper location a trouble free
operation even under adverse conditions can be achieved.
All information relating to the machine's status is displayed on the integral
graphic screen of the P 3100 HV, as is the menu navigation system. The screen
brightness can be adjusted to any of several levels (see chapter entitled 'Basic
settings of the P 3100 HV').

The displays and symbols shown on the screen vary according to the source
and settings which are currently active. The screen is divided into the following
areas:
 Display area (a) shows the source name.
 Display area (b) shows the volume level currently set.
 Area (c) shows symbols which indicate the current mode of operation.
(For details refer next page "Screen symbols and their meaning")