Standard Accessories - HIKOKI G 3623DA Bedienungsanleitung

NAMES OF PARTS (Fig. 1 – Fig. 15)
1
Motor
2
Nameplate
3
Lock pin
4
Side handle
5
Gear cover
Depressed center
6
wheel
7
M5 hex. socket bolt
8
Wheel guard
9
Filter
0
Switch lock
!
Switch
Auto mode indicator
@
switch
#
Battery
$
Latch
%
Charge indicator lamp
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
G3623DA: Cordless Disc Grinder
To reduce the risk of injury, user must read
instruction manual.
Always wear eye protection.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/EU
on waste electrical and electronic equipment and
its implementation in accordance with national law,
electric tools that have reached the end of their life
must be collected separately and returned to an
environmentally compatible recycling facility.
V Rated voltage
n
Rated speed
n
No-load rotation speed
0
min -1 Revolution or reciprocations per minute
Switching ON
Switching OFF
Battery level indicator
^
switch
Battery level indicator
&
lamp
*
Lever
(
Hex. bar wrench
)
Wheel washer (E)
q
Wheel nut
w
Wrench
e
With side guard
Abrasive cutting
r
wheel
t
Lock lever
y
Mode indicator lamp
u
Rubber cover
i
USB port
o
USB cable
Lock
Switching locks to the "ON" position
Disconnect the battery
Warning
Remaining battery indicator switch
Battery
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50% – 75%.
Lights ;
The battery remaining power is 25% – 50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 291.
Standard accessories are subject to change without notice.
APPLICATIONS
○ Removal of casting fi n and fi nishing of various types of
steel, bronze and aluminum materials and castings.
○ Grinding of welded sections or sections cut by means of
a cutting torch.
○ Grinding of synthetic resins, slate, brick, marble, etc.
SPECIFICATIONS
1. Power tool
Voltage
Rated speed
Outer dia.
Wheel Hole dia.
Thickness
Peripheral speed
Battery available for this tool*
Weight**
11
English
Model
G3623DA
36 V
5300 min -1
Auto mode: 3200 min
230 mm
22.23 mm
6 mm
80 m/s
BSL36B18
4.9 kg
-1