Dik Geurts Lars 1000 Installationsvorschrift Seite 43

IN S TA LLA TION M A N U A L
9.5.2 Modivar 5
9.5.2.1 Outside air connection
Outside air connections are available for these appliances as accessories. Assembly always takes place at
the bottom of the appliance.
When installing a RS appliance, the outdoor air connection is pre-mounted at delivery. If so, observe the steps
!Caution
described under the heading 'Outdoor air connection pre-mounted'.
Outdoor air connection not pre-mounted:
In case of these appliances, exhaust is only possible via the rear.
When mounting the outside air connection, please proceed as follows (see Appendix 2, fig. 10 and 11):
Ø
Loosen the 5 bolts that are pre-mounted on the outside air connection.
Ø
Bring the outside air connection against the plate on the bottom of the appliance.
Ø
Then re-tighten the 5 bolts.
Ø
Fasten the tray for the benefit of the rear connection with 4 bolts.
Ø
Connect the flexible hose to the round 'pipe opening' of the above-mentioned tray.
The flexible hose can only be fed from the rear.
The round pipe opening for the benefit of the lower connection is not needed during installation and should
!Caution
be disposed of responsibly
In case of a rear connection (see Appendix 2, fig. 10 a+b):
Ø
Fasten the tray for the benefit of the rear connection with 4 bolts.
Ø
Connect the flexible hose to the round 'pipe opening' of the above-mentioned tray. The flexible hose can only
be fed from the rear.
The round pipe opening for the benefit of the lower connection is not needed during installation and should
!Caution
be disposed of responsibly.
In case of a bottom connection (see Appendix 2, fig. 11 a+b):
Ø
Mount the supplied round pipe opening using 4 bolts.
Ø
Connect the flexible hose (Ø 80 mm) to this pipe opening.
The tray with round pipe opening for the benefit of the rear connection is not needed during installation
!Caution
and should be disposed of responsibly.
Outdoor air connection pre-mounted:
Ø
Connect the flexible hose (Ø 80 mm) to the round 'pipe mouth' of the outdoor air connection.
In the case of an RS appliance, you are dealing with a fully closed system. This means that you must always ensure
!Caution
an airtight connection of the flexible hose to the round 'pipe mouth' by using heat resistant sealant.
43