Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
.
b.
Use safety equipment. Always wear eye
protection. Safety equipment such as dust
mask, non-skid safety shoes, hard hat, or
hearing protection used for appropriate
conditions will reduce personal injuries.
c.
Avoid accidental starting. Ensure the
switch is in the off position before plug-
ging in. Carrying power tools with your
finger on the switch or plugging in power
tools that have the switch on invites
accidents.
d.
Remove any adjusting key or wrench
before turning the power tool on. A
wrench or a key left attached to a rotating
part of the power tool may result in per-
sonal injury.
e.
Do not overreach. Keep proper footing
and balance at all times. This enables
better control of the power tool in unex-
pected situations.
f.
Dress properly. Do not wear loose cloth-
ing or jewellery. Keep your hair, clothing
and gloves away from moving parts.
Loose clothes, jewellery or long hair can be
caught in moving parts.
g.
If devices are provided for the connec-
tion of dust extraction and collection
facilities, ensure these are connected
and properly used. The use of these
pieces of equipment reduce hazards
caused by dust.
3.4 Power tool use and care
a.
Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job better
and safer at the rate for which it was
designed.
b.
Do not use the power tool if the switch
does not turn it on and off. Any power
tool that cannot be controlled with the
switch is dangerous and must be repaired.
c.
Disconnect the plug from the power
source before making any adjustments,
changing accessories, or storing power
tools. Such preventive safety measures
reduce the risk of starting the power tool
accidentally.
d.
Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
18
7062788-Batavia-Multiheater-MA-1702-28.indb 18
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e.
Maintain power tools. Check for mis-
alignment or binding of moving parts,
breakage of parts and any other condi-
tion that may affect the power tools
operation. If damaged, have the power
tool repaired before use. Many accidents
are caused by poorly maintained power
tools.
f.
Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
g.
Use the power tool, accessories and
tool bits etc., in accordance with these
instructions and in the manner intended
for the particular type of power tool,
taking into account the working condi-
tions and the work to be performed. Use
of the power tool for operations different
from intended could result in a hazardous
situation.
3.5 Service
a.
Please use a qualified expert who uses
original replacement parts to repair your
power tool. This will ensure proper func-
tioning of the power tool.
4 Additional safety instructions
When using electric tools, basic safety
precautions should always be followed
to reduce the risk of fire, electric shock
and personal injury.
Read all these instructions before
attempting to operate this product and
save these instructions.
4.1 Before using the appliance
•
Check the following:
–
Make sure the voltage of the hot air gun
corresponds with the power voltage;
–
Are the mains lead and the mains plug in a
good state: strong, without ravels or
damages.
•
Caution is advised when using long exten-
sion cables.
•
Do not use the appliance under moist
circumstances;
15-03-17 10:59
Werbung
Inhaltsverzeichnis
