Technical Specifications - Sanitas SGS 43 Gebrauchsanweisung

No measurement possible
Possible errors
The scale was not activated before being
stepped on. If you step onto the scale before
„0.0" appears in the display,
it will not function correctly.
Interference between scale and
control panel.
The control panel is too far from the scale.
The scale batteries are flat.
The connection between control panel and scale
is interrupted.
Incorrect weight measurement
Possible errors
Scale is on carpet.
Scale zero setting is incorrect.

13. technical specifications

Scale batteries
Control unit batteries
Measuring range
Weight
Transmission
Subject to technical modifications.
4 x 1.5 V AAA
2 x CR2032 lithium batteries
1 kg to 150 kg
100 g
Infrared transmission
Remedy
Activate the scale correctly (wait for „0.0")
and repeat the measurement.
Switch on the control panel and the scale before the
measurement.
If necessary, wait 30 seconds and then repeat the
measurement.
Remove and replace the batteries in the scale and
control panel or make sure that the transmitter and
receiver are not covered.
Reduce the distance between the scale and control
panel.
Replace the batteries (see page 14).
Do not cover the receiver and transmitter.
Remedy
Place scale on a flat, solid surface.
Switch on scale and wait until it switches off auto-
matically (LED off). Then repeat measurement.
16