KRAFTWELE i5000 OFFEN Bedienungsanleitung Seite 34

Translation of the original manual.
HOW TO USE
IMPORTANT! For best power and maximum life, a new generator should be run at 50% load for 20 hours to achieve the
best possible performance.
1. Connect the ground.
2. Start the engine.
3. When the output indicator light is off and the overload indicator light is on, turn the engine switch to the STOP position
and the engine will shut down immediately to restart.
4. Make sure the device to be used is turned off and plug the device to be connected into an AC outlet.
5. Turn on the device to be used.
6. If there is an overload or a problem with the device in use, the output power indicator light (green) will go out, the
overload indicator light (red) will stay on and the power will be interrupted.
7. The engine, however, does not automatically shut off, but must be turned off by setting the appropriate engine switch in
STOP position.
ATTENTION!
• When using devices that require high switching power, such as motors, etc., the overload indicator light (red) and
the output power indicator light (green) may light up simultaneously for a while (about 4 seconds), but this is
perfectly normal. When the device is turned on, the overload indicator light (red) goes off, while the output power
indicator light (green) stays on. • The DC socket should only be used to charge 12 V batteries, and the voltage at
the load
neutral is 15-30V.
CHARGING 12V BATTERIES
ATTENTION! In DC mode, set the active throttle switch to the OFF position.
1. Connect the charging cables (B) to the DC socket (A) on the generator and then to the battery posts.
ATTENTION! The DC socket can also be used while using the AC socket.
12