Radio Installation - Albrecht AE 6891 Bedienungsanleitung

•
Detached operation via 9-pin Sub-D cable (approx. 2m length) supplied incl. screws
(installation accessories)
•
User manual with Radio Passport
You can operate your AE 6891 in the car or as a base station at home. For installation as a
mobile station in the car a mobile holder and a variety of installation materials are included.
Do not install the device in direct sunlight, since the increased temperature can shorten the
lifecycle of the device. Do not install in close proximity to a heater. Install the device in such
way that it is not subjected to major vibration.
Install the mobile holder with the included self-tapping screws on dashboard, chassis tunnel
or in other suitable location. Do not install the device in areas where it can cause injuries due
to accident (observe sufficient legroom). Ensure not to damage existing cables during
installation!
Slide the radio into the mobile holder. Fix the device with the large knurled screws (use the
included plastic washers!) in the desired view angle. Detach the front panel (loosen 2 screws
at the bottom) if installation of the complete unit is not possible and install the radio separate
from the control panel. Install the microphone bracket with the included screws in an easy to
reach location.
For detached installation use the included approx. 2m long 9-pin Sub-D cable.

Radio Installation

4
Side view detached
panel.
Fix the cable with the screws
after installation!
The installation material includes
the two screws for the plug if not
already attached to the cable.
control