Eibenstock EHD 2002 S Originalbetriebsanleitung Seite 15

Keep the handles dry, clean, and free of oil and grease.

Do not touch rotating parts.

Persons under 16 years are not allowed to use the tool.

During use, the user and other persons standing nearby have to wear

suitable goggles, helmets, ear protectors, dust mask, protective cloves
and boots.
During manual operation, always hold the tool with both hands

and be fall-safe. Consider the tool's reaction torque in case of
blocking.
Always work with concentration. Always work in a carefully

considered way and do not use the tool if you are lacking
consideration.
During manual operation, work with a special circumspection

when dry drilling with dimensions between 100 and 132 mm!
For further safety instructions, see the enclosure.
The EHD 2002 S is designed according to protective class II.
Prior to putting the tool into operation, check the mains voltage for conformity
with the requirements of the tool's nameplate.
Voltage variations between + 6 % and – 10 % are permissible.
The tool includes a start-up speed limiter to prevent fast expulsion fuses from
unindented responding.
Only use extension cables with a sufficient cross-section. A cross-section
which is too small could cause a considerable drop in performance and an
overheating of machine and cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
110V
230V
Additional Handle
For manual drilling, the EHD 2002 S may be used only together with its
additional handle which comes with the tools. Place it on the gearing collar
from the front and fix it by counterclockwise rotation.
Electrical Connection
Cross section in sq. mm
1.5
20 m
50 m
14
2.5
40 m
80 m