SWOOP CITY 28 WOMAN Anleitung Seite 56

ADJUSTMENT - REAR DÉRAILLEURS
The Low limit screw determines how far the rear dérailleur will travel
toward the wheel of the bicycle, while the High limit screw determines
how far the cage will travel toward the frame.
1. Shift the rear shifter to the largest number indicated, disconnect
the rear derailleur cable from the cable anchor bolt and place the
chain on the smallest sprocket.
2. Adjust the High limit screw so the chain and the smallest sprocket
are lined up vertically. Remove any slack in the cable by pulling it
out, then reconnect the cable and tighten the cable anchor bolt
securely.
3. Shift up through the gears making sure that each gear is achieved
quietly and without hesitation. If noise occurs, use the barrel
adjuster to fine-tune the cable tension. Turning the barrel adjuster
clockwise will decrease cable tension and allow the dérailleur cage
to move further away from the bicycle in small increments. Turning
counter-clockwise will increase cable tension ard bring the cage
closer to the bicycle. This will micro-adjust the positioning of the
dérailleur cage in relation to the freewheel. Simply put: turn the
barrel adjuster the direction you want the chain to go.
4. Shift the chain onto the largest sprocket: adjust the low limit screw
so the chain and the largest cog are lined up vertically. If you are
unable to get the chain to the largest cog, turning the Low limit
screw counter-clockwise will enable the chain to move towards the
wheel.
5. Shift through the gears ensiling each gear is achieved quietly and
without hesitation.
NOTE: It may take several adjustments to achieve the desired
positioning. Please refer to the troubleshooting section for more
assistance.
Freewheel
Guide Pulley
Tension Pulley
Rear Derailleur Rear View
High Gear
Adjustment Screw
Low Gear
Adjustment
Screw
SIS Cable
Adjuster
25
Top Gear
Pulley Adjustment
Screw
Adjustment
Screws
SIS Cable Adjuster
Rear Derailleur Side View