SWOOP CITY 28 WOMAN Anleitung Seite 53

These brakes require breaking in! Ride and use the brakes gently for 13
miles before using the brakes in downhill conditions, for sudden stops,
or any other serious braking. Please be aware that your brake system
will change in performance throughout the wear-in process. The disc
brake should be cleaned before the first ride using rubbing alcohol.
NEVER use oil or similar products to clean your disc brake system.
Avoid touching the rotor (disc} with your fingers at any time. Naturally
oily fingers can contaminate the rotor and/or the brake pads and
diminish the brake's effectiveness.
Hub
Disc Mounting
Bolts
Disc
Fork Drop Out
Quick Release lever
DÉRAILLEUR
Although the front and rear dérailleurs are initially adjusted at the
factory, you will need to inspect and readjust both before riding the
bicycle.
Centering Bolt
Fork Leg
Brake Cable
Housing
Rotating Rod
Caliper Body
Cable Boot with
Spring inside
Centering Bolt
(inside)
Actuating
Cable Anchor
Arm
Bolt
Caliper Mounting
Bolts with spacers
REAR DÉRAILLEUR
Begin by shifting the rear shifter to largest number indicated, disconnect
the cable from the rear dérailleur cable anchor bolt, and place the chain
on the smallest sprocket.
Adjust the High limit screw so the guide pulley and the smallest sprocket
are lined up vertically. Reconnect the cable, pull out any slack, and
retighten the anchor bolt securely. Shift through the gears, making
sure each gear achieved is done quietly and without hesitation. If
necessary, use the barrel adjuster to fine tune the cable tension by
turning it the direction you want the chain to go. For example,
turning clockwise will loosen the cable tension and move the chain away
from the wheel, while turning counter-clockwise will tighten cable
tension and direct the chain towards the wheel. Shift the rear shifter
to the gear one and place the chain on the largest cog.
Freewheel
Guide Pulley
Tension Pulley
22
Pulley Adjustment
Screw
Adjustment
Screws
Cable Barrel
Adjuster