Starting And Stopping - Husqvarna LC 348VI Classic Bedienungsanweisung

Starting and stopping

Before starting
WARNING! Please read the operator's
!
manual carefully and make sure you
understand the instructions before using
the machine.
Wear personal protective equipment. See
instructions under the "Personal
protective equipment" heading.
• Keep people and animals well away from the working
area.
• Perform daily maintenance. See instructions in the
section "Maintenance".
• Ensure the ignition lead sits correctly on the spark
plug.
Manual Start
The engine brake handle must be held against the
handlebar when the engine is started.
LB 348V, LC 348V, LC 353V
• Position yourself behind the machine.
• Grip the starter handle, slowly pull out the cord with
your right hand until you feel some resistance (the
starter pawls grip). Pull with force to start the engine.
Never twist the starter cord around your hand.
Electric Start
LC 348VI, LC 353VI
The machine has electric start via a start bar.
• Before using the electronic start for the first time you
need to activate the battery. See instructions in the
section "Maintenance".
Machines with electric start have a start inhibitor. Proceed
as follows to start the engine and blade rotation:
• Fit the battery in the intended compartment on the
engine and check the battery status.
For more information, see the "Battery" section.
80 – English
OPERATING
• Loosen the start inhibitor (1).
• Pull the start bar (2) towards you. The starter motor
will stop when the engine is started.
Drive
• To use the drive on the wheel pull the clutch lever
towards you.
When the drive starts feeling slow you need to adjust the
clutch wire. Finely adjust the wire using the adjuster
screw.
• To tension the wire and increase speed, screw the
adjustment screw counterclockwise.
Make sure the wires are not tensioned too tight. If the
lawn mower starts to drive withtout the clutch lever is
beeing operated, extend the wire.
• To extend the wire and reduce speed, screw the
adjustment screw clockwise.
Stopping
• Stop the engine by releasing the engine brake bar/
start bar. The drive is also disengaged when you
release the engine brake bar/start bar.
IMPORTANT!
Always remove the battery when the machine is not in
use or when the machine is left unattended.
1
2