Technical Data - Dräger X-plore 8000 Gebrauchsanweisung

3. Insert the tip of the expanding rivet into the visor bracket, so that the new
visor can easily be inserted.
4. Align the central bore hole in the visor with the expanding rivet and fasten
the visor with the expanding rivet.
5. Push the visor into the visor bracket until it snaps into place.
5.2.4 Replacing the sweatband
Illustration on the fold-out page (figure E)
1. Remove old sweatband from support ring.
2. Fasten a new sweatband on the hooks of the support ring.
5.2.5 Replacing the protective foil
1. If present, remove the old protective foil.
2. If necessary, wipe visor with a damp cloth and dry with a soft cloth.
3. Attach protective foil with the holes on the press studs on the visor.
5.2.6 Replacing the head harness
Illustration on the fold-out page (figure A-2)
1. Release the 6 fastening elements from the shell of the helmet.
2. To fasten the new head harness in the helmet, use the positioning aid to
attach the fastening elements to the front of the helmet.
3. Attach the other fastening elements to the corresponding position in the
shell of the helmet.
6 Transport
®
Transport the Dräger X-plore 8000 helmet with visor in the closed original
packaging.
7 Storage
®
Store the Dräger X-plore 8000 helmet with visor dry and clean completely
assembled in the original packaging and protect it from direct sunlight and
thermal radiation. Do not store near aggressive substances (e.g. solvents and
fuels).
Instructions for use |
Dräger X-plore 8000
8
The service life of the Dräger X-plore
used and maintained as described in these Instructions for Use. The service life
of the visor depends directly on the wear and tear it is subjected to. Extreme
conditions of use may reduce the service life.
The date of manufacture of the helmet is specified in figures on the label. The
visor's date of manufacture is coded (see 5.2.3 Replacing the visor).
Dispose of the product in accordance with the applicable rules and regulations.
9
Operating temperature:
Storage temperature:
Operating/storage area humidity:
Material:
Visor:
Face cuff:
Visor bracket:
Sweatband:
Protective foil:
Helmet shell:
Values on noise attenuation of the earmuffs
Frequency [Hz]
125
250
500
1000
®
Helmet with Visor
Disposal
®
8000 helmet with visor is 5 years if it is

Technical data

-5 °C to +50 °C
-5 °C to +55 °C
≤ 90 % relative humidity
polycarbonate or acetate
PU-coated PA
PA
PA, foamed
PET
ABS
1)
Average values
16.8
19.1
27.6
34.7
| en
Transport
Standard deviation
3.2
2.1
2.4
3.2
19