Assembly Of The Dti Cooling Unit (Installation) - Pfannenberg DTS 6401-Seire Betriebsanleitung

ENG
4.5.3

Assembly of the DTI cooling unit (Installation)

4.5.3.1 Making cut-outs for DTI cooling unit
Fig. 12: External view switch cabinet, assembly cut-outs
1 Air inlet
2 Air outlet
Prerequisites
DANGER – Danger to life due to electric shock. Make sure that the unit is voltage-free.
• All general requirements are met, see "General", Page 29.
Required tools and materials
• Saw
• Switch cabinet mill if necessary
• Protective covers
Procedure
1. Ensure that the switch cabinet has a protective cover to protect against chips.
Provide switch cabinet with cut-outs. For prescribed dimensions, see Fig. 12.
2.
3. The four cut-out corners can be made rectangular or with a max. radius of 4 mm.
4. Deburr the cutting edge.
5. Remove chips and assembly waste from the switch cabinet.
The cut-outs and holes are made and the cooling unit can be assembled.

Operating Manual | Attachment and Installation Cooling Units | Standard Controller (SC) – 230 V | 086100119
3 Device contour
4 Assembly cut-out
G00009
32/66