Flex L 8-11 125 Originalbetriebsanleitung Seite 21

L 8-11 115 / L 8-11 125 / LE 9-11 125
Press and hold down the spindle lock.

Tighten the clamping nut with the face

spanner.
Carry out a test run to check that the tool

is clamped in the centre.
Test run
Insert the mains plug into the socket.

Switch on the angle grinder with the

switch (without engaging it) and run the
angle grinder for approx. 30 seconds.
Check for imbalances and vibrations.
Switch off the angle grinder.

Switching on and off
Brief operation without engaged switch
rocker
Push the switch rocker forwards and

hold in position.
To switch off the power tool, release

the switch rocker.
Continuous operation with engaged
switch rocker
Push the switch rocker forwards (1.) and

engage by pressing the front end (2.).
To switch off the power tool, release

the switch rocker by pressing the rear
end.
NOTE
Following a power failure, the switched on
power tool does not restart.
Preselecting the speed
(only LE 9-11 125)
To set the operating speed, move the dial
to the required value.
CAUTION!
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
NOTE
If an overload or overheating occurs during
continues operation, the power tool auto-
matically reduces the speed until the power
tool has cooled down adequately.
21