Stihl iMOW 6.0 EVO Gebrauchsanleitung Seite 73

8 Installing the Perimeter Wire
the main mowing area (A) through the corri‐
dor (1) to the other mowing area (B). Starting
points can be set using the MYiMOW
► If it is not possible to maintain the minimum
width between the perimeter wires: Block off
the other mowing area (B) from the main mow‐
ing area (A) and install an adjacent area.
8.13
R R
L L
L
R
L R
► Route the perimeter wire (4) as illustrated and
make sure that the correct position of the wire
loops (5) has been maintained:
– The wire loops (5) must be routed to the
left = (L) in the direction of travel to the
docking station.
– The section where the perimeter wires (4)
lie close and in parallel to each other are on
the right = (R) in the direction of travel to the
docking station.
a
d
4
► Route the perimeter wire (4) as illustrated and
make sure that the following dimensions have
been maintained:
– Width between the perimeter wires in the
corridor: a = 55 cm
– Minimum distance to side obstacles:
b = 15 cm
0458-012-9601-A
®
app.
4
5
b
d
c
b
– Minimum corridor length: c = 74 cm
®
(2x iMOW Ruler)
– Distance of perimeter wires of the wire loop:
d = 37 cm (length: 1x iMOW
e
90°
► When installing the guide wire (2), make sure
that the following dimensions and distances
are maintained:
– The guide wire (2) is installed in the center
of the corridor.
– Route guide wire (2) before the corridor for
a length of at least e = 37 cm (length:
®
1x iMOW Ruler) in a straight line and at a
right angle (90°) to the corridor.
– Route guide wire (2) after the corridor for a
length of at least f = 2 m in a straight line
and at a right angle (90°) away from the cor‐
ridor.
8.12 Inclines/slopes
The robot mower can navigate and mow inclines
up to 45%. With the Upgrade Kit 10, iMOW
traction wheels gradients of up to 60 % can be
driven and mowed. The Upgrade Kit 10 is availa‐
ble as a special accessory.
► If there is an incline/slope up to 27% within the
mowing area: Install perimeter wire normally.
English
®
Ruler)
f
90°
®
73