Technaxx TX-192 Gebrauchsanleitung Seite 56

• Drill the two bottom holes into the wall and insert the dowels. Use a
hammer for a flush finish with the wall. Screw in the screws. Make sure
they are not completely screwed in.
• Hang the camera onto the two screws with the bottom holes.
• Now mark the top holes.
• Remove the camera.
• Drill the two top holes into the wall and insert the dowels. Use a hammer
for a flush finish with the wall.
• Again, hang the camera onto the two screws with the bottom holes.
• Screw in the top screws to mount the device safely.
Model: TX-192 Article No. 4991, 07/2022
13