ESX Quantum QE1000.1 Benutzerhandbuch Seite 17

The BASS BOOST controller adjusts the bass boost continuously from 0 dB to +18 dB at 40 Hz on channel pair 3/4.
14
NOTE: Always use this controller with care. A permanently too high bass boost could damage your speakers!
15 If your head unit does not have RCA preamp outputs, you can use the amplifier's HIGH LEVEL INPUT as the signal input. To do
this, simply connect the loudspeaker cables of the head unit to the enclosed cable plug as follows:
L R
+ +
L R
– –
White:
White-Black:
Gray:
Gray-Black:
16 The REMOTE port is for connecting the cable of the included bass level remote controller. With this, the bass level can be e.g.
be adjusted from the driver's seat. Only use the supplied bass remote controller and the associated cable. The bass level remote
controller only works in LP/BP mode.
NOTE
Installation of RCA/Audio signal cables and power supply cables.
Ensure while installation not to lead the audio cables between the head unit and the amplifier together with the power supply wires
on the same side of the vehicle. The best is a real separated installation on the left and right cable channel of the vehicle to avoid
interferences on the audio signal. This stands also for the enclosed bass-remote wire, which should not be installed together with the
power supply wires.
FUNCTIONAL INSTRUCTIONS
Left front +
Left front –
Right front +
Right front –
17