Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3-channel-mode: 1 x Stereo-System and 1 x Mono Subwoofer
Connect stereo RCA outputs (FL/FR & RL/RR or
SUB OUT) of the head unit with INPUT CH1 / CH2
and CH3 / CH4 of the amplifier
INTERCONNECTION
• Connect the RCA line outputs of the head unit with the RCA jacks INPUT of the amplifier with appropriate high-value RCA cables.
If a separate SUB OUT from your head unit is available, use this for the INPUT CH3/4 on the amplifier.
• Connect the speakers with SPEAKER OUTPUT + CH 1 - and + CH 2 -, and the subwoofer with the SPEAKER OUTPUT CH3/4
+ BRIDGED - of the amplifier.
• Always ensure that the total impedance load per channelpair (CH1 & CH2) is not lower than 2 ohms and the total impedance load
of the subwoofer (CH3 & CH4) is not lower than 4 ohms. Too low impedance cause high temperature and will shut down the
amplifier operation.
INPUT MODE-Schalter
• Refer to the notes on page 18.
CROSSOVER SETTINGS CH1/2 (STEREO SYSTEM)
• Refer to the notes on page 18.
LEVEL INPUT CONTROLLER CH1/2 (STEREO SYSTEM)
• Refer to the notes on page 18.
BASS BOOST CONTROLLER CH1/2 (STEREO SYSTEM)
• The BASS BOOST controller must be turned to 0 dB position in this interconnecting example .
CROSSOVER SETTINGS CH3/4 (SUBWOOFER)
• Refer to the notes on page 19.
LEVEL CONTROLLER CH3/4 (SUBWOOFER)
• Refer to the notes on page 19.
BASS BOOST CONTROLLER CH3/4 (SUBWOOFER)
• The BASS BOOST controller adjusts the bass enhancement between 0db and +12dB.
BASS REMOTE CH3/4 (SUBWOOFER)
• The enclosed BASS REMOTE CONTROLLER adjusts the bass-level e.g. from the driver's seat of the subwoofer on CH 3/4.
Please use only this enclosed bass remote controller and cable.
20
FUNCTIONAL INSTRUCTIONS
INTERCONNECTION EXAMPLE
Loudspeaker
2 – 8 Ohms
HP or FULL
4CH
LP/BP
Connect Bass Level
Controller with the
enclosed cable
Loudspeaker
left, front
right, front
2 – 8 Ohms
Subwoofer
4 – 8 Ohms
Werbung
Inhaltsverzeichnis
