Troubleshooting - fors TP860-2 Benutzerinformation

Cleaning the drum
WARNING! Disconnect the
appliance before you clean it.
Use a standard neutral soap detergent to
clean the inner surface of the drum and
drum lifters. Dry the cleaned surfaces with
a soft cloth.
CAUTION! Do not use
abrasive materials or steel wool
to clean the drum.
Cleaning the control panel and
housing
Use a standard neutral soap detergent to
clean the control panel and housing.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
Error Codes
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists,
contact the Authorised Service Centre.
WARNING! Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an
error code and the
Error code
E5A
E97
Start/Pause button may flash continuously:
Possible cause
Appliance motor overloaded.
Too much laundry or entrap in the
drum.
Internal fail. No communication be‐
tween electronic elements of the
appliance.
Use a moist cloth to clean. Dry the
cleaned surfaces with a soft cloth.
CAUTION! Do not use furniture
cleaning agents or cleaning
agents which can cause
corrosion.
Cleaning the airflow slots
Use a vacuum cleaner to remove fluff from
the airflow slots.
The programme was not comple‐
ted. Remove the laundry from the
drum, set the programme and re‐
start the cycle.
The programme was not finished
properly or the appliance stoped
too early. Switch the appliance off
and on again.
If the error code appears again,
contact the Authorised Service
Centre.
21
Remedy