Troubleshooting - fors TP 8359 Benutzerhandbuch

18
CAUTION! Do not use furniture
cleaning agents or cleaning
agents which can cause
corrosion to clean the appliance.

TROUBLESHOOTING

1)
Problem
The tumble dry-
er does not op-
erate.
Unsatisfactory
drying result.
The loading
door does not
close
Possible cause
The tumble dryer is not connected
to the mains supply.
The door is open.
The On/Off (Ein/Aus) button was
not pushed.
The Start/Pause button was not
touched.
The appliance is in standby mode.
Incorrect program selection.
The filter is clogged.
Dryness (Trockengrad) option
was set to iron dry (Bügeltrock-
4)
en).
The load was too large.
The airflow slots are clogged.
Dirt on the humidity sensor in the
drum.
Dryness level not set to desired lev-
el.
The condenser is clogged.
The filter is not locked into position.
Laundry is trapped between the
door and the seal.
Cleaning the airflow slots
Use a vacuum cleaner to remove fluff from
the airflow slots.
Connect to the mains socket.
Check fuse in fuse box (domestic in-
stallation).
Close the door.
Push the
ton.
Touch the
Push the
ton.
Select a suitable program.
Clean the filter.
Change
option to higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bottom
of the appliance.
Clean the front surface of the drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct position.
Remove trapped items and close
the door.
Remedy
On/Off (Ein/Aus) but-
Start/Pause button.
On/Off (Ein/Aus) but-
2)
3)
Dryness (Trockengrad)
5)
3)