Safety Instructions; Electrical Connection - fors TP860-2 Benutzerinformation

pillows fitted with foam rubber pads should not be dried in
the tumble dryer.
Fabric softeners, or similar products, should only be used
•
as specified by the product manufacturer's instructions.
Remove all objects from items that could be a source of
•
fire ignition such as lighters or matches.
WARNING: Never stop a tumble dryer before the end of
•
the drying cycle unless all items are quickly removed and
spread out so that the heat is dissipated.
Before any maintenance operation, deactivate the
•
appliance and disconnect the mains plug from the socket.

SAFETY INSTRUCTIONS

Installation
Warning: Risk of fire / Flammable
materials.
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Follow the installation instructions
supplied with the appliance.
• Do not install the appliance in an
environment with no air exchange
The appliance contains flammable gas,
propane (R290), a gas with a high level
of environmental compatibility. Keep
fire and ignition sources away from the
appliance. Be careful not to cause
damage to the refrigerant circuit
containing propane.
• Always take care when moving the
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
• Do not install or use the appliance
where the temperature can be lower
than 5°C or higher than 35°C.
• The floor area on which the appliance
is to be installed must be flat, stable,
heat resistant and clean.
• Make sure that there is air circulation
between the appliance and the floor.
• Always keep the appliance vertical
when it is being moved.
• The rear surface of the appliance must
be put against a wall.
• When the appliance is in its permanent
position, check if it is levelled correctly
with the aid of a spirit level. If it is not,
adjust the feet accordingly.

Electrical connection

WARNING! Risk of fire and
electric shock.
• Connect the mains plug to the mains
socket only at the end of the
installation. Make sure that there is
access to the mains plug after the
installation.
• The appliance must be earthed.
• Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power
supply.
• Always use a correctly installed
shockproof socket.
• Do not use multi-plug adapters and
extension cables.
• Do not pull the mains cable to
disconnect the appliance. Always pull
the mains plug.
• Do not touch the mains cable or the
mains plug with wet hands.
5