fors TP860-2 Benutzerinformation Seite 22

22
Error code
EH0
If the display shows other error codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible
solutions.
Troubleshooting
Problem
You cannot activate the appliance.
The programme does not start.
The appliance door does not close.
The appliance stops during operation.
The cycle time is too long or unsatisfactory
1)
drying result.
Possible cause
The mains supply is unstable. When the appliance is showing
EH0, please wait until main supply
is stable than press start. If the ap‐
pliance pause the cycle without
any indication then press the cycle
start. If the warning will occur
check the power cord / socket in‐
tegrity or main supply.
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Check fuse in fuse box (domestic installa‐
tion).
Press Start/Pause.
Make sure that the appliance door is closed.
Make sure that the installation of the filter is
correct.
Make sure that the laundry is not caught be‐
tween the appliance door and the rubber
seal.
Make sure that the water container is empty.
Press Start/Pause to start the programme
again.
Load is too small, increase the load or use
the Zeitprogramm (Time Drying programme.
Make sure that the weight of the laundry is
suitable for the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in
the washing machine again.
Remedy