Assembling - T+A 500 Betriebsanleitung

Assembling

Unpacking
Removing the transport
plate
Assembling
Please read right through these instructions before you start assembly;
this will avoid damage, and ensure that your Solitaire CWT SE
loudspeakers are assembled correctly.

If possible the plinth plates should be installed with the help of a second person!
This is the procedure for installing the plinth plate:
 Stand the cardboard box upright before opening it!
 Grasp the transport plate by the handle, and withdraw the loudspeaker
forward out of the box, keeping it upright.
 Lay the loudspeaker down on its back, just as it was stored in the box, i.e.
complete with the foam packing pieces and protective sleeve.

Remove the four retaining screws, followed by the transport plate, as shown
in Fig.1.
21
Fig. 1