Safety Information; Meaning Of The Signal Words; Observe Instruction Manual; Putting Into Operation, Use And Disassembly Only By Qualified Personnel - GF SPC Betriebsanleitung

Operating Instructions
2

Safety Information

2.1

Meaning of the signal words

In this instruction manual, warnings are used, which shall warn the user of death, injuries or material damage. Always read and
observe these warnings!
DANGER!
Imminent danger!
Non-observance may result in major injuries or death.
► Measures to avoid the danger.
WARNING!
Possible danger!
Non-observance may result in serious injuries.
► Measures to avoid the danger.
CAUTION!
Dangerous situation!
Non-observance may result in minor injuries.
► Measures to avoid the danger.
NOTE!
Dangerous situation!
Non-observance may result in material losses.
2.2

Observe instruction manual

The instruction manual is part of the product and an important component within the safety concept. Non-observance may lead to
severe injuries.
Read and observe instruction manual.
•
Always have instruction manual available by the product.
•
Give instruction manual to all subsequent users of the product.
•
2.3

Putting into operation, use and disassembly only by qualified personnel

Product and accessories should exclusively be put into operation or taken out of service by persons who have the necessary
•
training, knowledge, or experience.
Regularly instruct personnel on all questions regarding the local regulations applying to occupational safety and environmen-
•
tal protection, especially for pressurized pipes.
The following target groups are addressed in these operating instructions:
Operators: Operators are instructed in the operation of the product and observe the safety guidelines.
•
Service staff: The service staff have been professionally trained and carry out maintenance work.
•
2.4

Storage and transport

The product must be handled, transported and stored with care. Please note the following points:
► Transport and store the product in its unopened original packing.
► Protect the product from harmful physical influences such as dust, heat, humidity and UV radiation.
► The product and its components must not be damaged either by mechanical or thermal influences.
► Store the product with the lever in the open position (delivery state).
► Check the product for general damage prior to installation.
Type SPC positioner
9