GRAUPNER GM- RACER 3D Montageanleitung Seite 43

The Parts List also includes components which are not included in the kit. These have to be obtained
separately.
You will also need the following items (not included in the kit, Order No. 9564)
1 x COMPACT 300 7.2 V
4 x C 1041 servo
1 x XP 10 FM 35 MHz receiver
1 x Flight battery, 3 LiPo 1000 11.1 V / 1000 mAh
Optional accessories and tools (not included in the kit)
1 x Styrofoam cyano-acrylate glue
1 x Cyano activator spray
1 x Sanding block
1 x Glass-reinforced adhesive tape
For the colour scheme shown in the kit box illustration
2 x Styrofoam paint, red
2 x Styrofoam paint, black
2 x Styrofoam paint, silver
1 x Spray-Master
Radio control system
1 x MC-12 35 MHz radio control set, Order No. 4724
Other Graupner / JR FM radio control systems are also suitable for this model.
Part Numbers of the laser-cut parts
Converting the power system to a variable-pitch propeller
1. Take a snake outer sleeve with an internal diameter of 2 mm and run it through the fuselage nose,
terminating approximately level with the rear pushrod guide 27. Run a 2 mm Ø carbon fibre rod through
the sleeve, and fix the plastic clevises to the carbon rod as described under point 32.
2. Install the propeller pitch servo at around the receiver position.
All of us in the GRAUPNER TEAM hope you have loads of fun
building and operating your version of the GM-RACER 3D.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten!
Order No. 7708
Order No. 5116.LOSE
Order No. 7020
Order No. 7625.3
Order No. 5820
Order No. 953.150
Order No. 1067
Order No. 98709
Order No. 928.2
Order No. 928.7
Order No. 928.6
Order No. 945.50
ID# 0057121
43
02/2006