Switching Off; Assembly; Replacing The Saw Belt; Disassembling The Saw Belt - EFA SB 326 Originalbetriebsanleitung

Hearing impairment!
Ear protection is recommended
when used in continuous oper-
ation!
Always wear the personal pro-
tective equipment recom-
mended!
Work instructions
 The machine is equipped with a two-hand
safety circuit.
 Hold the machine firmly at both switching
handles, never work one-handed.
 Work particularly carefully when the ma-
chine is switched on.
 Protective equipment on the saw must not
be removed to complete cutting.
 To aid safe handling (guidance), the saw
should be hung on a spring balancer.
 After switching on the saw, never reach into
the area of the saw belt.
 Do not actuate the motor switch when in-
stalling the saw belt.
 Check the suspension for damages regu-
larly.
 Take heed of the general safety instructions,
see section "Safety instructions".

4.2 Switching off

 Lift your fingers off the switch lever.
 The switch goes off automatically due to the
return spring and then locks.
When the splitting saw is switched off, the saw
belt stops moving immediately.

5 Assembly

Assembly work may only be
carried out by authorised spe-
cialist personnel.
Disconnect the machine from
the mains before starting any
assembly work!
Schmid & Wezel

5.1 Replacing the saw belt

5.2 Disassembling the saw belt

 Open both lids (A) by their flaps (B) (each lid
has its own magnetic catch).
 Loosen the saw belt by turning the torque
wrench (C) anti-clockwise.
 This will slacken the saw belt.
 Lift guiding implement and lever (D), push
saw belt out of the guides and take belt off
the wheels (see section 5.3 Saw belt gui-
des).
Direction of
saw belt motion
Fig. 4 Replacing the saw belt
Lever D
up = working position
down = guide slackened for saw belt replace-
ment

22. Assembling the saw belt

 Smoothly fit the saw belt over the wheels,
teeth against the housing; the teeth must
face the motor. Check that the teeth fit into
the recessed diameter of the wheels to pro-
duce grip (free-wheeling see next figure).
Seite / Page
21 / 33
Only use original EFA spare
parts!
The saw belt to be replaced
only if the units are discon-
nected from the mains!
Never reach into the area of
the moving saw belt. Risk of
cutting off extremities!
Stand / Version
01 / 2020