WIKA DI10 Betriebsanleitung Seite 23

6.5.1 Limit values, limits, hysteresis
Menu level Parameterization level
Limit values/Limits, LI-1:
LI-1
For both limit values, two different values can be
parameterized. With this, the parameters for each limit value
are called up one after the other.
Hysteresis for limit values, HY-1:
HY-1
For both limit values, a hysteresis function exists that reacts
according to the functional principle (operating
current/quiescent current).
Function if display falls below/exceeds limit value, Fu-1:
Fu-1
To indicate if the value falls below the lower limit value, Louu
can be selected (LOW = lower limit value) and if it goes
above the upper limit value, HIgH can be selected (HIgH =
upper limit value). LOW corresponds to the quiescent current
principle and HIgH to the operating current principle.
WIKA Betriebsanleitung Digitalanzeige Typ DI10
0 0 0
0 0 0
Louu
HIgH
(Low)
0
0
23