Mac Prosint 2 And Eurosint 2 Or An - Oleo-Mac BC 22 Betribs- Und Wartungsanleitung

· Wipe spilled fuel from the unit. Move 3 metre
away from refueling site before starting
engine.
· Never attempt to burn off spilled fuel under
any circumstances.
· Do not smoke while handling fuel or while
operating the unit.
· Store fuel in a cool, dry, well ventilated place.
· Never place the machine in a combustible
area such as dry leaves, straw, paper, etc.
· Store the unit and fuel in an area where fuel
vapors cannot reach sparks or open flames
from water heaters, electric motors or
switches, furnaces, etc.
· Never take the cap off the tank when the
engine is running.
· Never use fuel for cleaning operations.
· Take care not to get fuel on your clothing
GASOLINE
·
l
1
5
10
15
20
25
This product is powered by a 2-cycle engine and
requires pre-mixing gasoline and 2-cycle oil.
Pre-mix unleaded gasoline and 2-cycle engine
oil in a clean container approved for gasoline.
RECOMMENDED FUEL: THIS ENGINE IS
CERTIFIED TO OPERATE
GASOLINE INTENDED FOR AUTOMOTIVE USE
WITH AN OCTANE RATING OF 89 ([R + M] / 2) OR
HIGHER.
Mix 2-cycle engine oil with gasoline according to
the instructions on the package.
We strongly recommend the use of 2% (1:50)
Oleo-Mac two cycle engine oil, which is
specifically formulated for all Oleo-Mac air-
cooled two-stroke engines.
The correct oil / fuel proportions shown in the
table (Fig. A) are suitable when using the Oleo-

Mac PROSINT 2 and EUROSINT 2 or an

equivalent high-quality engine oil (JASO
OIL
2%-50 : 1 4%-25 : 1
l (cm ) l (cm
3 3
0,02 (20) 0,04 (40)
0,10 (100) 0,20 (200)
0,20 (200) 0,40 (400)
0,30 (300) 0,60 (600)
0,40 (400) 0,80 (800)
0,50 (500) 1,00 (1000)
ON UNLEADED
specification FD or ISO specification L-EGD).
When oil specifications are NOT equivalent or
unknown use 4% (1:25) oil / fuel mixing ratio.
CAUTION: DO NOT USE AUTOMOTIVE
OIL OR 2-CYCLE OUTBOARD OIL.
CAUTION:
- Match your fuel purchases to your
consumption; don't buy more than you will
use in one or two months;
- Store gasoline in a tightly-closed container
in a cool, dry place.
CAUTION - For the mixture, never use a
fuel with an ethanol percentage higher than
10%; gasohol (mixture of gasoline and
ethanol) up to 10% ethanol or E10 fuel are
A
acceptable.
NOTE - Prepare only the quantity of mixture
required for immediate use; do not leave fuel in
)
the tank or a container for a long time. Were
commend the use of the additive Emak ADDITIX
2000 code 001000972 if the mixture is to be
stored for 30 days.
Alkylate gasoline
CAUTIONS – Alkylate fuels have
different density than normal fuel. Therefore
engines, set with normal fuel, need different
H jet regulation to avoid critical issues. For
this operation it's necessary turned at a
Licensed Service Dealer.
FILLING THE TANK
Stir the mixture well before refuelling.
PREPARING TO WORK
HARNESS
Correct adjustment of the harness permits the
brush cutter to be properly balanced and at an
appropriate height from the ground (Fig. 10).
- Put on the single harness.
- Hook the brush cutter to the harness using the
hook (A, Fig. 10).
- Position the hook (19A, Fig. 1) to obtain the best
GB
27