CombiSteel 7178.0510 Betriebs- Und Wartungsanleitung Seite 9

ATTENTION: Any part replacement that may affect safety must be carried out by the
authorized people. During maintenance and repair, keep the main gas valve closed and keep
away fire. Always perform leakage check after repair or part replacement; use foam or gas
detector for this aim. In case of any dangerous condition with the device, notify to the authorized
service. Do not allow unauthorized people to interfere in the device.
DANGEROUS: Never allow leakage check to be performed with flame.
Problem
The ignition flame does not
start
Yellow ignition flame
The burner does not operate
The ignition flame is not
maintained
Compatibility Information
This device is designed and manufactured in accordance with the following directives and
standards.
marking directive, 93/68/EEC
TS EN 203-1 / Gas Powered Cooking Appliances – Part 1:General Safety Appliances
TS EN 203-2-1 Gas Fired Catering Equipments - Part 2-1: Specifications – Open-tops
TS EN 203-2-2 Gas Burning Devices – Part 2-2: Special Rules – Ovens
 Limitation of Liability: All technical information contained in this manual, operating
instructions, operation and maintenance of the device, contains the latest information on your
device. The manufacturer accepts no responsibility for damage or injury which may result
from failure to follow the instructions in this manual, use outside of the intended use,
unauthorized repair, unauthorized modifications to the device, or use of spare parts not
approved by the manufacturer.
Cause
1- blocked gas pipe to the
2- ignition burner
3- blocked ignition burner
4- blocked ignition nozzle
1- air adjustment required
2- contaminated burner
1- damaged gas shut-off valve
1- contaminated thermocouple
2- the thermocouple does not
indicate voltage (mV)
3- the thermocouple is loose
4- damaged thermocouple
Table 1
Problem
1- check and remove
2- check and remove
3- clean with small steel brush
4- check and replace
1- check and remove
2- check and clean with brush
1- check and replace
1- check and clean with small steel brush
2- check and remove
3- check and remove
4- check and replace
9