Intended Use; Foreseeable Misuse; Safety Devices - HEYLO DT 960 Betriebsanleitung

Dehumidifier DT 960
As soon as the evaporator is free of ice, the device
starts returns to dehumidifying operation.
NOTICE
Condensate
The amounts of condensate and ice produced by
the device depend on the actual operating condi-
tions (air temperature and air humidity).
The performance of the device should be primari-
ly determined by the rate at which it reduces the
air humidity and not by the amount of water ex-
tracted from the air. To measure the humidity in
the air, use a thermo hygrometer.
See also
 Intended use
[ 34]
14.2.1

Intended use

The device is intended exclusively for dehumidify-
ing air in enclosed rooms at atmospheric pressure.
Proper use of the device is only possible, if all
persons who operate it have read, understood and
adhere to the operating instructions. Proper use
also includes strict adherence to the operating
conditions (see Operating conditions
device must be tested and serviced at regular
intervals.
The device is solely intended for industrial and
commercial use.
Any other use is deemed improper. Improper use
shall void all warranty.
See also
 Technical details [
14.2.2

Foreseeable misuse

The following types of misuse are foreseeable:
– Drying air in rooms that are not enclosed, or in
outdoor areas,
34 / 51
[ 31]). The
47]
– drying air without adhering to the specified
minimum spacing and operating conditions.
14.3

Safety devices

If the safety devices are not properly installed and
configured, there is a risk of serious injury to per-
sons. Do not modify, dismantle or disable safety
devices. All the safety devices must be freely ac-
cessible at all times.
Familiarise yourself with all safety devices; this
way personal injury and/or damage to property
can be prevented or minimised.
The following illustration shows the safety devices
of the dehumidifier.
Fig. 12:
Safety devices
1 Grille covering air
inlet opening
The device features the following safety devices:
Signalling devices
The indicators on the control panel indicate the
operating status of the device (for details, see
Control and display elements
2 Housing
[ 35]).
EN