Audio Settings; Speaker Settings; System Information - Tascam BD-MP1 Bedienungsanleitung

Audio Settings

Audio Output
Function
S/PDIF
HDMI
FS Setting
Volume Control
Dolby DRC
* Select Bitstream when using for surround sound connected to an AV amplifier, for example. In order to use bitstream, the connected device
must support it.
** The downsampling frequency used during audio playback for signal processing inside the unit can be set. If an audio signal is played that
has a sampling frequency higher than the selected value, it will be converted to the set sampling frequency. PCM signals output by HDMI
and S/PDIF connectors will also be downsampled to the set value.

Speaker Settings

Function
Configuration
Test Tone
* Lt/Rt is a two-channel downmix output that supports Dolby surround. When played on an ordinary stereo system, the L and R
channel balance could be degraded. If this occurs, select Stereo.
** Trim adjustment overview
Digital full scale (-10dB) is shown as "0" to make adjustment of surround channel speaker volume differences easier.
If trim adjustment is unnecessary, use the default setting (+10).
S/PDIF Output Configuration
Function
Configuration
* The maximum audio level will become -10 dBF only for L/R

System Information

Use to check the revision and the MAC address used by this unit.
o Model: BD-MP1
o MAC: xx-xx-xx-xx-xx-xx
o Revision: xxx.xxx
Options
Bitstream/PCM/Off
Bitstream/PCM/Off
48 kHz/96 kHz/192 kHz
Enable/Disable
Off/On/Auto
Options
2.x/3.x/4.x/5.x/6.x/7.x
More...
Options
p FL/FR
p SL/SR
p C/SW
p SBL/SBR
p L/R (-10dBF)
Explanation
This selects the digital audio signal format. *
This selects the HDMI audio format.
This selects the sampling frequency. **
Volume up/down operations can be enabled or disabled.
Set the dynamic range to Off, On or Auto.
Explanation
The channel configuration can be selected. The speaker size can be
set, and the trim and delay can be adjusted for each channel.
The trim can be adjusted in a range from −10 dB to +10 dB in 0.5dB
increments.**
The delay can be adjusted in a range from 0 cm to 1000 cm in 5cm
increments.
The delay time is 29μsec/cm.
Configuration
2.x: Lt/Rt*, Stereo
3.x: LCR
4.x: LRLsRs
5.x: -
6.x: -
7.x: C+LR+LsRs+LsrRsr
The speaker size can be set, and the trim and delay can be adjusted
while outputting a test tone from the speaker.**
Explanation
The selection items are the same signals that are output from the
analog outputs on the back of the unit.
The selected analog outputs are output from the digital audio
output (COAXIAL) connector.
Subwoofer selection
None, Single
23
TASCAM BD-MP1