Removing / Replacing Clean-Water Tank; Replacing The Waste-Tank; Ausbauen / Wiedereinsetzen Des - Numatic TTB-1840 Originalanleitung

Removing the Clean Water Tank
Fig 35
Replacing the Clean Water Tank
Fig 37
Replacing the Waste Water Tank
Fig 39
Regular Maintenance
Fig 36
Fig 37a
Fig 38
Fig 40
233970 (Page 36) 10/11 (A13)
Once the clean-water tank has been emptied, the tank can be
removed.
Firstly detach the water feed pipe from the tap, this can be
done by pushing the red tap clip in whilst pulling off the pipe.
(Fig 35).
The black suction hose from the
floor-tool simply pulls off the floor tool
(Fig 36).
Inside the clean water tank is a filter,
located below the clean water inlet
(Fig 36a)
Clean all hoses and filters by flushing
Fig 36a
with clean water.
Fit the suction hose to the floor tool (Fig 37) and pass through
the hole in the clean water tank (Fig 37a).
Place the tank onto the machine base.
NOTE:
Ensure the water feed pipe locates in the channel
moulded into the base of the tank (Fig 38).
Fig 38a
Fig 39a
Refit the separator and reconnect the vacuum and suction
hose (Fig 40).
The water feed pipe simply
pushes onto the tap. (Fig 38a).
Place the suction hose as shown
(Fig 39).
Place the tank onto the machine
(Fig 39a).