Machine Set Up; Fitting The Brushes; Fitting The Floor-Tool; Montieren Der Saugbalken - Numatic TTB-1840 Originalanleitung

!

Fitting the brushes

Featuring the Nulock brush system.
The brush is simply pushed and twisted to lock, making fitting and removal a simple process.
Only use manufacturer supplied brushes.
This machine requires a 400mm brush or a 360mm pad.
Safety gloves are recommended for the changing of used brushes.
Fitting the Floor Tool
The floor tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off
feature if the floor tool gets snagged, whilst in transit.
Machine Set-Up
ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED
BEFORE MAKING ANY ADJUSTMENTS
Fig 6
Fig 7
Fig 8
Secure to the carrier using the
two knobs fitted to the floor-tool
carrier (Fig 9) - (Fig 9a).
Do not over tighten the retaining
knobs.
Fig 9
233970 (Page 22) 10/11 (A13)
Slide the brush / pad under the brush deck (Fig 6).
Fit the brush / pad onto the Nulock drive chuck, twist to lock
the brush / pad in place (Fig 7).
Swing the floor-tool carrier to the side of the machine
(Fig 8).
Note:
It is easier to fit the floor-tool if the weight of the machine is
resting on the brush. Ensure the brush is fitted first.
!
Fig 9a