Battery Care; Removing The Battery Pack Fuse; Entfernen Der Akkupaket-Sicherung - Numatic TTB-1840 Originalanleitung

Removing the battery

Removing the battery pack fuse

Under abnormal use;
i.e. leaving the machine without charging for a period of time, we advise that you disconnect the battery from
If the machine will be standing unused for a period of 30 days or more, then batteries must be fully charged
Note.

Battery Care

Fig 48
Fig 49
Fig 50
Fig 51
Fig 52
Recharge the machine fully after its last use.
Do not leave the machine in a discharged state.
Batteries should be recharged every three months.
Charge fully the day before you start using the machine again.
233970 (Page 40) 10/11 (A13)
Unplug the battery from the machine using the red
connection handle (Fig 48).
The battery can then be lifted from the machine for
storage or charging (Fig 49).
The battery pack comes with a 40 amp safety
fuse fitted (Fig 50).
Remove the six screws holding the battery pack
together (Fig 51).
Split the pack and replace the fuse using
(208526) Numatic approved part (Fig 52).
the machine.