Scrapping Old Appliances - Candy CDDN700DSI Bedienungsanleitung

screws you removed previously.
15. Remove the screw that secures the door stops from
the bottom right of the freezer compartment door,
then remove the door stops and install to the
bottom left side.
Refrigerator door
16. Install the freezer compartment door.
17. Move the door bushing from the top right side of
the freezer door to the top left side of the door. And
move the left hole cover to the right side.
Door
bushing
18. Remove the screw that secures the hinge screw hole
cover from the top left side of the cabinet, remove
the cover and secures the cover on the top right side
of the cabinet.
Screws
Hinge screw hole cover
19. Secure the upper hinge to the top left side of the
cabinet with the three screws you removed
previously. Before you tighten the upper hinge
screws, make sure that the top of the door is level
with the cabinet and that the rubber gasket makes a
good seal.
20. Install the hinge cover over the hinge on the top left
side of the cabinet.
Hinge cover
Screws
Upper hinge
Door stops
Hole cover

SCRAPPING OLD APPLIANCES

This appliance is marked according to the European
directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE).
WEEE contains both polluting substances (which can
cause negative consequences for the environment) and
basic components (which can be re-used). It is important
to have WEEE subjected to specific treatments, in order
to remove and dispose properly all pollutants, and
recover and recycle all materials.
Individuals can play an important role in ensuring that
WEEE does not become an environmental issue; it is
essential to follow some basic rules:
- WEEE should not be treated as household waste;
- WEEE should be handed over to the relevant collection
points managed by the municipality or by registered
companies. In many countries, for large WEEE, home
collection could be present.
In many countries, when you buy a new appliance, the
old one may be returned to the retailer who has to
collect it free of charge on a one-to-one basis, as long as
the equipment is of equivalent type and has the same
functions as the supplied equipment.
20