Slope In Vertical Operation - THEIS VISION 2N Gebrauchsanleitung

3rd key press: Y flashes on the display.
You can now use the arrow keys to set the slope of the
Y axis in the same way as for the X axis.
4th key press: Confirms your input
After this, the device first starts levelling again, which is
shown by the flashing levelling display. After this, the
entered slope settings are approached.
During this procedure, the slope symbol blinks.
Once the values have been reached, the slope settings
and the slope symbol are displayed permanently lit.
If external influences (shock or temperature) change the
position of the device, the system interrupts rotation and
the laser beam, the slope and the warning display flash
rapidly.
If you press the slope key again, you can start grading
again, the device carries out levelling again and
approaches the stored slope settings again.
Important: The laser's mounting position and
possibly also the elevation and direction may,
however, have changed. This means that to be on
the safe side you should switch the device off and
back on again and adjust it.

5. Slope in Vertical Operation

In vertical operation too you can enter a grade. Of
course, you can only do this on the Y axis. To do this,
fix the laser in vertical position, start the laser and press
the X/Y key. Proceed as described in point 4.
29