Rotation - Speed; Slope - THEIS VISION 2N Gebrauchsanleitung

3. Rotation - Speed

The rotation speed can be regulated in four stages: 0,
200, 600 and 800 RPM. Pressing the rotation key two
times the laser stops 0 RPM). Each time you press the
key again, the rotation speed increases.
At a standstill, you can move the laser dot using the
counterclockwise/clockwise rotation keys. Pressing
and holding down one of the keys speeds up the
movement of the laser dot.

4. Slope

If the tripod is well-aligned, you can grade the laser on
two axes from -10% to +10%.
To do this, first use the optical sight to align the laser
exactly to the target point and then enter the slope
settings as follows:
1st key press: Grading is activated. The stored slope
settings of the last use are displayed and automatically
approached.
2nd key press: X, slope symbol and one digit of the
slope value flashes on the display.
Use the arrow keys to set the slope. The blinking digit
can be changed.
To select the digits you must press the counterclock-
wise/clockwise rotation keys. For changing the sign
use the ± button. Plus is not displayed.
When you press and hold the arrow - keys the values
in the display will start to increase slowly and speed up
than.
Pressing both arrow keys at the same time resets the
respective display to 0.
28