Radio Remote Control Fb-V (Option) - THEIS VISION 2N Gebrauchsanleitung

12. Radio Remote Control FB-V (Option)

The wireless remote control is designed on a bidirectional
basis. All the information that is shown on the laser's display
can also be seen on the lit-up display of the remote control. The
key symbols on the operator panel correspond to the keys on
the laser keypad. The MANUAL operating mode is missing
to ensure that it is not possible to enter this function by mistake.
Die FB-3 durch Drücken einer beliebigen Taste einschalten. Die
Switch on the FB - V by pressing any key. The remote control
automatically searches for an appropriate channel to rule out
disturbances to other devices.
On the display, you can see the same information as on the
display of the associated laser. If this is not the case and an
antenna symbol is displayed, this may be due to one of the
following reasons:
- The laser is not switched on
- The radio channel is not set correctly
- The remote control is out of range of the laser.
34